Aircrack-ng

User Tools

Site Tools

Trace:
shared_key

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
shared_key [2008/11/08 01:45] – fixed typo darkaudaxshared_key [2010/08/29 19:48] – Fixed channel/frequency graph link mister_x
Line 107: Line 107:
 In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
  
-To match the frequency to the channel, check out: +To match the frequency to the channel, check out: http://www.cisco.com/en/US/docs/wireless/technology/channel/deployment/guide/Channel.html#wp134132 .  This will give you the frequency for each channel.
-http://www.rflinx.com/help/calculations/#2.4ghz_wifi_channels then select the "Wifi Channel Selection and Channel Overlap" tab.  This will give you the frequency for each channel.+
  
 === Troubleshooting Tips === === Troubleshooting Tips ===
shared_key.txt · Last modified: 2018/03/11 20:19 by mister_x