airmon-ng
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
airmon-ng [2015/08/23 23:56] – Added troubleshooting tips mister_x | airmon-ng [2019/05/01 22:18] – [General] renamed troubleshooting section mister_x | ||
---|---|---|---|
Line 51: | Line 51: | ||
1115 wpa_supplicant | 1115 wpa_supplicant | ||
- | ===Turn monitor mode on=== | + | ===Enable |
**Note**: It is very important to kill the network managers before putting a card in monitor mode! | **Note**: It is very important to kill the network managers before putting a card in monitor mode! | ||
Line 75: | Line 75: | ||
As you can see, it created a monitor mode interface called wlan0mon and it notified there are a few process that will interfere with the tools. | As you can see, it created a monitor mode interface called wlan0mon and it notified there are a few process that will interfere with the tools. | ||
- | ===Turn monitor mode off=== | + | ===Disable |
~# airmon-ng stop wlan0mon | ~# airmon-ng stop wlan0mon | ||
Line 84: | Line 84: | ||
(mac80211 monitor mode vif disabled for [phy0]wlan0mon) | (mac80211 monitor mode vif disabled for [phy0]wlan0mon) | ||
- | And you might as well want to restart the network manager | + | Don't forget |
service network-manager start | service network-manager start | ||
Line 111: | Line 111: | ||
If you want to use ath0 (which is already used): | If you want to use ath0 (which is already used): | ||
- | airmon-ng stop ath0 | + | |
And the system will respond: | And the system will respond: | ||
Line 131: | Line 131: | ||
You can see ath0 is gone. | You can see ath0 is gone. | ||
- | To start ath0 in monitor mode: airmon-ng start wifi0 | + | To put wifi0 in monitor mode: |
+ | |||
+ | | ||
System responds: | System responds: | ||
Line 165: | Line 167: | ||
You can set the channel number by adding it to the end: airmon-ng start wifi0 9 | You can set the channel number by adding it to the end: airmon-ng start wifi0 9 | ||
- | |||
- | |||
- | ==== mac80211 drivers monitor mode ==== | ||
- | |||
- | See [[install_drivers# | ||
- | |||
- | When using the mac80211 version of a driver, the use of airmon-ng and the aircrack-ng tools are slightly different. | ||
- | |||
- | Running: | ||
- | |||
- | | ||
- | |||
- | Gives something like: | ||
- | |||
- | | ||
- | |||
- | | ||
- | (monitor mode enabled on mon0) | ||
- | |||
- | Notice that it created " | ||
- | |||
- | To remove monitor mode enter: | ||
- | |||
- | | ||
Line 233: | Line 211: | ||
===== Usage Troubleshooting ===== | ===== Usage Troubleshooting ===== | ||
- | ==== General | + | ==== Madwifi-ng |
Quite often, the standard scripts on a linux distribution will setup ath0 and or additional athX interfaces. | Quite often, the standard scripts on a linux distribution will setup ath0 and or additional athX interfaces. | ||
airmon-ng.txt · Last modified: 2022/02/09 00:34 by mister_x